AUG/18/56 Oaks Farm Bulmer Lane Holme on Spalding Moor East Yorkshire YO43 4HE #11864 · AUG/18/56

Completion Cert - 22/04/21

phone call from client confirms that restrictor fitted to the window as requested agreed to issue final cert jab

Final Inspection letter - 21/04/21

Final Inspection Letter - 21/04/21

RETIREMENT LETTER SENT

rang client complete other than certificar]tion for gas electric and EPC will forward when got and we will arrange a final inspectio0n jab

clients number 07816546109

rang client requested update on progress left message to call me back asap jab

file audit phone call to client says will contac t office when all works complete jab

01132562295 ella wright

Calcs added to file.

Drainage letter - Acceptable
24.09.18

james templey 07725138470

Hi Robert and James

The attached are;

• Plasmor SAP Specification and reports
• Dwg 700/100A Building Regulations notes

I refer you to the SAP Specification final entry. SAP result – PASS – Elemental U Value Pass required only

Leanne has prepared the SAP specification and reports using her own U value calculations. I am aware their accreditation system requires SAP Assessors to undertake their own calculations and essentially, not believe those supplied to them! It’s a good job as the British Gypsum ones that I obtained via the British Gypsum website calculator were slightly over specifying. The thickness of Thermaline has reduced from 80mm to 70mm. Consequently, my Regs notes have been revised accordingly.

The email trail below is between Leanne and me to finalise the various elements for the SAP. One matter is the ceiling above the living room area. The SAP is resolved to raise the flat roof ceiling area to nom 2750mm. This introduces a small area of sloping (raking) ceiling, which is included in the SAP and Regs notes.

I trust this is acceptable to you both.

Cheers

Steve

Steve Jenneson

Jenneson Associates Ltd

sap reports

Please find attached dwg 700/100 Building Regulations specification notes, together with three British Gypsum U value calculations and specifications.

I’ve included an lpg boiler for heating the barn conversion. I do recall you saying that you may consider an air source heat pump. But, I had to gamble and the lpg boiler is the worse of the two for SAP compliance. In other words, if you do use the air source heat pump then the SAP will improve.

Ii is perhaps worth saying that you require both SAP and EPC for Building Control but they don’t actually need to show a pass, as this is conversion. The primary driver is compliance with the U values stated in the Regs and used in this specification.

I trust this assists all of you.

Cheers

Steve

Steve Jenneson

Jenneson Associates Ltd

Business office - May Cottage, Mill Lane, Seaton Ross, York, YO42 4NE. Tel No 01759 318200. Fax No 01759 318210. www.jennesonassociates.co.uk

Cheque received £948

IN Acceptance - 21/08/18

The project was marked as 'Won'

The project was created